All Knowledge & Insights By Date

The July 3, 2012, edition of the National Institute for Occupational Safety and Health (NIOSH) eNews includes a nanotechnology update, which states that the critical question to address is whether nanomaterials pose health or safety risks to workers employed in their manufacture and industrial use. The update includes the following “notable recent findings and areas of research”:...

The U.S. Environmental Protection Agency (EPA) announced on July 2, 2012, the availability of an external review draft document entitled Nanomaterial Case Study: A Comparison of Multiwalled Carbon Nanotube and Decabromodiphenyl Ether Flame-Retardant Coatings Applied to Upholstery Textiles (EPA/600/R-12/043A). EPA states that the draft document “does not draw conclusions regarding potential environmental risks or hazards of multiwalled carbon nanotubes (MWCNT); rather, it aims to identify...

The NanoRelease Project is intended to support the development of methods to understand the release of nanomaterials used in products. To do this, the Project will: (1) examine full life cycles of nanomaterials in products; (2) work through specific release scenarios at key exposure points of the life cycle; (3) organize existing material characteristics data and measurement methods for those release scenarios; (4) develop a “state of the science” report for release measurement; and (5)...

The U.S. Environmental Protection Agency (EPA) has announced that, in response to public comments, it will provide the public more time to comment on the December 28, 2011, proposed significant new use rules (SNUR) for 17 chemical substances that were the subject of premanufacture notices (PMN). Of particular interest, seven of the PMN substances’ reported chemical names include the term “carbon nanotube” (CNT) or “CNT.” EPA states “the comment period is being...

The U.S. Environmental Protection Agency (EPA) published on December 28, 2011, proposed significant new use rules (SNUR) for 17 chemical substances that were the subject of premanufacture notices (PMN). Of particular interest, seven of the PMN substances’ reported chemical names include the term “carbon nanotube” (CNT) or “CNT.”  EPA states that because of a lack of established nomenclature for CNTs, the Toxic Substances Control Act (TSCA) Inventory names for CNTs are...

On September 18, 2011, Nature Nanotechnology posted an article entitled “Cell entry of one-dimensional nanomaterials occurs by tip recognition and rotation.” The authors state that materials with high aspect ratio, such as carbon nanotubes (CNT) and asbestos fibers, have been shown to cause length-dependent toxicity in certain cells because these long materials prevent complete ingestion, which frustrates the cell. The authors note that, while “[b]iophysical models have...

On May 6, 2011, the U.S. Environmental Protection Agency (EPA) promulgated a final significant new use rule (SNUR) under Section 5(a)(2) of the Toxic Substances Control Act (TSCA) for the chemical substance identified generically as multi-walled carbon nanotubes (MWCNT), which was the subject of premanufacture notice (PMN) P-08-199. Under the final SNUR, persons intending to manufacture, import, or process MWCNT for a use that is designated as a significant new use by the final rule must...

The National Institute for Occupational Safety and Health (NIOSH) released a draft Current Intelligence Bulletin (CIB) entitled Occupational Exposure to Carbon Nanotubes and Nanofibers, which recommends that, until results from research studies can fully elucidate the physicochemical properties of carbon nanotubes (CNT) and carbon nanofibers (CNF) that define their inhalation toxicity, employers should take steps to minimize CNT and CNF exposures of all workers and implement an occupational...

On September 22, 2010, the California Department of Toxic Substances Control (CDTSC) and the U.S. Environmental Protection Agency (EPA) held a public workshop on state and federal nanomaterial activities. During the workshop, CDTSC and EPA discussed the results of California’s data call-in (DCI) for carbon nanotubes (CNT), its plans for future DCIs, and EPA’s efforts related to CNTs. The candidate chemicals for CDTSC’s second DCI, which it intends to issue this Fall, include...

On September 17, 2010, the U.S. Environmental Protection Agency (EPA) issued final significant new use rules (SNUR) for two chemical substances that were the subject of premanufacture notices (PMN). The two chemical substances are identified generically as multi-walled carbon nanotubes (MWCNT) (PMN P08177) and single-walled carbon nanotubes (SWCNT) (PMN P08328). Persons who intend to manufacture, import, or process either of these substances for a use that is designated as a...